Navigation gear ensures you get the place you need to be whereas out on the road. Even for those who did not spring for the navigation choice when you first bought your Buick Enclave, you’ll be able to install a conveyable GPS navigation system to your windshield or dashboard in just some minutes. The facility outlet on the Enclave’s dashboard makes sure your unit won’t run out of power throughout lengthy road trips.
Buick Enclave Navigation Installation Instructions
1. Clean the realm in your windshield or dashboard where you will mount the GPS. Make sure the unit won’t obstruct your view of the road. If you are utilizing an adhesive disk, peel the paper backing from the disk and press it into place on the desired location.
2. Place the suction cup mount of the GPS navigation on the specified location on the windshield or on the adhesive disk.
3. Press the mount into place and flip the lever at the base to safe it to the surface. Align the markings on the rear of the GPS receiver with the cradle on the mount. Push the receiver on the cradle until it clicks into place.
4. Insert one end of the GPS energy cable into the miniUSB port on the side of the receiver and plug the opposite finish into the power outlet on the dashboard of the Enclave. The GPS navigation will routinely turn on and acquire the necessary satellites for navigation.
5. Flip in your Enclave’s engine to ensure the GPS receiver is not depleting your battery.
